-OCD Typhon rear cab only body mount-

*Not a perfect fit for OCD Slither*

Rear holes do not line up perfect on slither. We use decorative washers to help pinch the chassis. If you plan to use this product on Slither, please reach out to us to see how we do it.

The perfect way to hold down the rear of your cab only body. This mount is proprietary to our OCD Customs Typhon Chassis. This mount is two pieces. One piece that gets screwed to the chassis and skid plate (OCD Typhon skid plate) and one channel that pinches and holds the rear of the cab only body. This mount has about one inch of forward to rear adjustment to make mounting bodies quick and easy!

See more info below:

Typhon rear cab mount works best in unison with these listed products:

-OCD Unicorn mount/ Unicorn mount with hood stacks

-OCD Typhon Chassis rails

-OCD Typhon Skid Plate

**Install tip**

This channel on the mount grabs the body hard! It can and will remove the paint from your body where it grabs. If you would like to help remedy that, install a piece of electrical tape on the body to protect it from the jaws of the channel. Also, the channel has two small dimples in it where the periods are in O.C.D. You can drill two small holes in your cab only body to line up with those dimples to keep the body from moving left and right.

-*DISCLAIMER* THIS IS A 3D PRINTED PART! DO NOT OVER TIGHTEN SCREWS AS THE HOLES CAN STRIP!

Product will come with supplied fasteners